Avipoint™ Bird Spikes

Quality bird spikes designed to ensure effective and humane urban bird management solutions for gulls and feral pigeons

Models Available
AVIPOINT™ P14
AVIPOINT™ P20
AVIPOINT™ P32
Special Clips
Specialist Adhesives

View Photo Gallery

Avipoint™ bird management spikes are manufactured in the United Kingdom, in a unique and highly automated process, to ensure the highest quality standards.

The Avipoint™ "P" series can be used to protect buildings against pigeons in a wide range of situations, from daytime perching to night roosting sites and from the narrowest of pipes to the widest of building ledges.

If areas are weather protected – beneath overhangs, in window heads, under canopies bird spikes are best not used. Spikes are most effective when fitted on exposed areas and for gulls and pigeons.

Product Specifications

Available in three models, AP14, AP20 & AP32.
The base is UV light-protected polycarbonate, with breakable sections.
The spikes are a heavy-duty 1.4mm in diameter and are made from 302 grade stainless steel, cut flat to prevent injury to both installers and birds.
These spikes are moulded into the base for improved durability.
Marine grade stainless steel P32 bird spikes are an option.
As a guideline, use P32 (32 wires to 33.3cm piece) for gulls and pigeons

› View complete specifications / models ...

Key Bird Spike Features

Stackability

Easy Storage, Transport and Installation

Carton lots of 10 stacks or 50 lineal metres.
Each product is supplied in a 15 strip stack, sufficient to treat up to 5 metres of ledge.
Stacks enable easier handling
Each product is supplied in a 15 strip stack, sufficient to treat up to 5 metres of ledge.

Glue Groove

Quick and Easy Glue Application

On the underside of the base is a unique"glue groove" which allows the installer to quickly and easily apply adhesive to the base from a caulking gun.
Holes in the groove are designed to allow 'rivets' of glue to form, when the strip is pressed onto the surface, to ensure the strip will be securely anchored.
Alternatively, screw or rivet the bird spike base but thoroughly seal the penetration.
Recommended adhesive: a ‘neutral cure’ RTV product suited to the surface being fixed to.

Installation of Avipoint Bird Spikes

Preparation:

Clean the surface of lichen, slime, atmospheric dirt & bird contamination etc.
Wire brush (then wipe or wash off) the surface being fixed to, if appropriate.
A primer coat of paint will help provide a better key for the adhesive if the integrity of the surface is suspect to you.
Application: When fitted on a ledge or parapet, the bird spike should protrude 5mm past the outer edge of the parapet.
Apply a generous quantity of adhesive, position the spike and press down firmly.
If complete coverage of the surface is required, refer to guidelines for each ‘P’ model.
It is normal to mix & match for different surface widths: refer to photo with P32 on the parapet and sign infill, but P14 on the narrow sign frames.

Avipoint on light

Control pigeons and seagulls
Control Gulls and Pigeons

- View Photo Gallery -

For a free supply and/or installation estimate Contact Ace Birdproofing now